Thingiverse
Nicol Bolas Magic Deck Box
von Printlapse
39
Downloads
16
Likes
0
Makes
A simple Deck Box but as of right now, the 'hinge' doesn't last long but it works perfectly initially.
Instructions:
Print both out and attach the back/lid to the box itself with some sort of glue. To insure it doesn't move while setting, place it on it's back and put some sort of weight in the box (DON'T USE CARDS).
If the hinge fails, a similar colored tape works fine in its place.
DISCLAIMER: KEEP YOUR CARDS IN SLEEVES TO AVOID DAMAGING THEM!
I do not own any Magic: The Gathering cards to test it fro 115 cards but it fits +90 Yu-Gi-Oh cards with sleeves so it should work.
There is a Red Eyes version of this deck box for you Yu-Gi-Oh fans that uses this same design that I made. Check it out.
Instructions:
Print both out and attach the back/lid to the box itself with some sort of glue. To insure it doesn't move while setting, place it on it's back and put some sort of weight in the box (DON'T USE CARDS).
If the hinge fails, a similar colored tape works fine in its place.
DISCLAIMER: KEEP YOUR CARDS IN SLEEVES TO AVOID DAMAGING THEM!
I do not own any Magic: The Gathering cards to test it fro 115 cards but it fits +90 Yu-Gi-Oh cards with sleeves so it should work.
There is a Red Eyes version of this deck box for you Yu-Gi-Oh fans that uses this same design that I made. Check it out.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!