Night light ballerina

I made a modification to the original design to use the ballerina as a night light. The design incorporates a previous modification where the user changed the base and support. I successfully printed two versions: the first in its original size, which resulted in a ballerina that was too small for the base. Then I printed a second version where I made the ballerina approximately 150mm tall and reduced the scale by 5mm in relation to the arm. I made a 1mm hole in the palm of the ballerina's hand and at the top of the arm where I installed a nylon thread, with some knots at each end to secure it in the holes. This created a freer movement. To finish, I used the same resin to glue and cover the holes.
The design was printed on a Photon Mono X with water-washable clear resin. For better transparency, after curing I brushed the print with the same resin, finished with final curing and washing of the model.
The models available for download are not pre-drilled; you will need to drill the 1mm