Thingiverse
Nightcore Bulb & Base
por mrjamesv
4
Descargas
4
Likes
0
Makes
Bulb and base for a nightcore flashlight (MH2C) to turn a nightcore flashlight into a lamp for camping etc.
The flashlight can be switched on or off by pressing the whole thing down.
I printed the bulb in a translucent white PLA filament and the base in black PLA.
It works way better than the cone shaped diffuser I bought for it and subsequently lost - it gives a nice even bright light and so far does not get too hot.
The base has a slot to allow the cord to fit in and a raised nub to activate the switch when pushed down
The flashlight can be switched on or off by pressing the whole thing down.
I printed the bulb in a translucent white PLA filament and the base in black PLA.
It works way better than the cone shaped diffuser I bought for it and subsequently lost - it gives a nice even bright light and so far does not get too hot.
The base has a slot to allow the cord to fit in and a raised nub to activate the switch when pushed down
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!