Nightmare II. HueForge

Picture source Pinterest, autor not found.Then used HueForge v0.9.1 to create the model. Important info! Slicing this model takes quite a while, about 3-4 minutes depending on the performance of your PC, so please be patient! The Model is 150x200mm in size. You can only modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct. You may print at higher layer heights below the Base Thickness of 0.56mm. The Max allowed Thickness is 2.32mm and the Actual Thickness is 2.32mm. Filaments Used:PLA Elegoo + Black Transmission Distance: 0.3 PLA Sunlu META Grey Transmission Distance: 3.6 PLA Elegoo + Gray Transmission Distance: 3 PLA Elegoo Basic White Transmission Distance: 7This print uses 4 unique filaments Swap Instructions: Start with Black At layer #12 (1.04mm) swap to Grey At layer #15 (1.28mm) swap to Gray At layer #20 (1.68mm) swap to White for the rest. Share your prints and…Boost MeThank you!