Nightstand leg risers

I needed to raise the bottom of our nightstands so that the robotic vacuum would not get stuck. The first risers were silver and about 1/4” too big (see photo 98% scaled). Since these were out at our farm I had to wait to try them. I reprinted them in black at 90% scale). I will post an updated photo if I get them on this weekend.

Fusion 360 was used to create and save the .stl file

This was my first creation from scratch. I've only been printing for less than a month. My turn to give back since I have freely used so many Thingiverse files.

The black risers were printed at 90%, the silver risers were printed at 98%.
The black PETG was printed at 30mm/s, 220/80C, .2mm layers, 5 hours
The silver PLA was printed at 60mm/s, 190/55C, .2mm layers, 2.5 hours
Both were 15% infill lattice