Nikkai SSR Covers

This is a a terminal cover for the Nikkai SR-T1A2020TK Solid State Relay (SSR). It's not a common SSR, due to cost, so I couldn't find any covers for it. It's more expensive than most because its a quality relay, not like the clones that are littered everywhere.

You will need to print 2 of these, one for each side. The side that doesn't have a sidewall faces towards the terminals. The screw hole is for a M3 screw of the length of your choosing based on your application. Orient with the "danger" facing down.

The top (printed on the bottom) and sides are 2mm thick.The text goes 0.6mm deep. Danger text is added since this is using AC mains (120v). Printed at 0.2mm layer heights, that gives you 3 layers where then you can do a filament swap so that the "DANGER" text is more apparent. You'll see that in the pictures. I used a bright green color for the first 3 layers so that it's easily visible in the darker area this will be at, and then red after the 3rd layer so that the danger not