Thingiverse
Nikon D750 OK Button
von fform
2
Downloads
3
Likes
0
Makes
Printed at 10% infill in PLA on a Prusa i3MK2S, took about 5 min.
The OK button on my Nikon D750 fell off. I couldn't find a reference so this is my best guess as to the design. This should pressure fit in the slot. The pin in the middle might need to be trimmed after printing to get it clicking just right.
The OK button on my Nikon D750 fell off. I couldn't find a reference so this is my best guess as to the design. This should pressure fit in the slot. The pin in the middle might need to be trimmed after printing to get it clicking just right.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!