MakerWorld
Hueforge & Lithophane
Zum Modell
Ninja Halloween hueforge
3
Downloads
7
Likes
0
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 170.5x227.33mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 3mm and the Actual Depth is 3mmFilaments Used: PLA BambuLab Matte Charcoal PLA smartfill blanco frio PLA BambuLab Basic Orange This print uses 3 unique filamentsSwap Instructions: Start with Charcoal At layer #8 (0.72mm) swap to blanco frio At layer #19 (1.6mm) swap to Orange At layer #33 (2.72mm) swap to blanco frio for the rest.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
