Thingiverse
NinjaCookie Bottomless lower brackets
di 3DPModder
6
Download
5
Likes
0
Makes
I wanted to install Dual Z rods using Ninjacookies brackets, however My printer is flat against the surface with center brackets bolting it in place, so raising it wasn't something I was interested in.
Remixed the lower brackets to remove the base under the extrusion, then lowered the 4 holes that bolt into the horizontal extrusion by the same amount (4.5mm) so they would line up in the new configuration.
Remixed the lower brackets to remove the base under the extrusion, then lowered the 4 holes that bolt into the horizontal extrusion by the same amount (4.5mm) so they would line up in the new configuration.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!