Thingiverse
Nintendo GameCube Controller Wire Spool
von 16bitvirtual
2
Downloads
5
Likes
0
Makes
Need a neat and tidy way to store your controllers. Well this is my solution for it.
To assemble you will need to print our nut hammer and 5, 10x32 nuts and ½" screws
If you don't have a 3D Printer I can make it for you from my stores on eBay and etsy
etsy - http://www.16bitgamestore.etsy.com/
eBay - https://www.ebay.ca/usr/16bitvideogamestore
To assemble you will need to print our nut hammer and 5, 10x32 nuts and ½" screws
If you don't have a 3D Printer I can make it for you from my stores on eBay and etsy
etsy - http://www.16bitgamestore.etsy.com/
eBay - https://www.ebay.ca/usr/16bitvideogamestore
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
