Thingiverse
Nintendo Switch Folding Stand
von jd52wtf
148
Downloads
122
Likes
1
Makes
Early version of folding stand design for the Nintendo Switch. This requires an M4 X 20mm screw to fasten. Holds the Switch far enough off the table to allow for the charging connector to be attached while it is being played. Includes a pass through for the power cable to the rear.
Further refined version without the watermark can be purchased here.
https://www.etsy.com/listing/503618326/nintendo-switch-folding-stand-highly
Further refined version without the watermark can be purchased here.
https://www.etsy.com/listing/503618326/nintendo-switch-folding-stand-highly
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
