Thingiverse
Nintendo Switch Game Toaster
von R0CC0336
96
Downloads
105
Likes
1
Makes
This is a widened and shortened version of the SD Card Holder. This allows for it to now fit two Nintendo Switch game cards.
Print-in-Place with no supports. The interior may need some clean-up due to slight bridging issues but nothing a small flat head screw driver can't break free.
The dimensional accuracy of the circle nob at the bottom is a little lost because all I did was stretch and compress the model in TinkerCad. I'm not smart enough to do it any other way so here it is.
This is a remix of an original design by Dehapro
Print-in-Place with no supports. The interior may need some clean-up due to slight bridging issues but nothing a small flat head screw driver can't break free.
The dimensional accuracy of the circle nob at the bottom is a little lost because all I did was stretch and compress the model in TinkerCad. I'm not smart enough to do it any other way so here it is.
This is a remix of an original design by Dehapro
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
