Nintendo Switch JoyCon Holder Mount Improved

I really liked the controller mount Deanasawr designed, but I struggled to keep the controller mount glued to the dock.
I also thought there was room to improve the design in terms of printability so I went on and worked on top of it.

The main changes are:
- Remove overhangs to reduce material wast
- Remove adhesive space. I guess this was intended as a space for glue to fill or for somewhat thick tape. I'm planning to use a pretty strong double-sided tape, so I filled that space
- Redesign the controller mount to have a bigger glue/tape area. This should resolve the mount falling off due to the greater controller weight

The models for the controller mount have no built-in tolerance, so if your printer is not perfectly calibrated you're likely to have to do some sanding for it to fit.
You can set up some x/y size compensation on your slicer configuration to make up for it.