Thingiverse
Nintendo Switch Joycon-Tripod Mount
von asimon1
2
Downloads
0
Likes
0
Makes
Use this adapter to mount the joycons to a camera tripod for precise motion controls.
Use a standard 1/4-20 nut with 7/16" A/F distance in the hex hole to attach to the tripod mounting plate. The press fit is tight so you may need to use the thread to pull the nut into the hole.
The side slots hold the joycon rails snugly, and two LED viewing slots are included to check the connection status to the switch.
I used these hex nuts: https://www.mcmaster.com/95462A029/
No supports are necessary. Print the part standing up instead of laying flat.
Use a standard 1/4-20 nut with 7/16" A/F distance in the hex hole to attach to the tripod mounting plate. The press fit is tight so you may need to use the thread to pull the nut into the hole.
The side slots hold the joycon rails snugly, and two LED viewing slots are included to check the connection status to the switch.
I used these hex nuts: https://www.mcmaster.com/95462A029/
No supports are necessary. Print the part standing up instead of laying flat.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!