Thingiverse
Gadgets
Go to Model
Nintendo Switch OLED Dock Cradle
140
Downloads
167
Likes
3
Makes
I store my switch on a shelf with a ceiling and sometimes it can be a little cumbersome to dock vertically. Figured I'd fix the problem by creating a solution to dock horizontally.
- This will NOT work with a non-OLED dock.
- There are no supports needed for this print.
- Includes 4 recessed holes on the bottom so you can install non-slip rubber feet. Diameter is 13mm, but anything smaller will work as well.
- There are holes on both left and right sides to allow HDMI and USB cables to exit.
- Took the time to eliminate all sharp corners/rough edges.
- This will NOT work with a non-OLED dock.
- There are no supports needed for this print.
- Includes 4 recessed holes on the bottom so you can install non-slip rubber feet. Diameter is 13mm, but anything smaller will work as well.
- There are holes on both left and right sides to allow HDMI and USB cables to exit.
- Took the time to eliminate all sharp corners/rough edges.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
