Nintendo Switch RCM Jig

This is another printable RCM jig.


What makes this file different than the other designs?

1) Its designed so that installing the wire is straightforward and very easy. There is no need for wire jigs since the part is the jig.

2) The wire used in this design is from twist ties, so its readily available and free.

3) The wire is compliant and much less likely to damage the switch connector. It is designed to slide over the contact without any sharp edges in direct contact with the switch connector contacts. On other designs with paper clips, the ends may be jagged and damage the connector trace as it slides over it.

4) The wire is fully supported by the 3D printed plastic material and will not permanently deform and lose contact over the design life.

5) By angling the ends of the wire down, the wire does not have any sharp ends which may damage the connector traces on the switch. It also prevents the wire from being pushed out as you slide it into the co