Nintendo Switch Screen Protector Guide
von KBilly1313
7
Downloads
8
Likes
0
Makes
Nintendo Switch Screen Protector Application Guide or Jig
Just a quick design to help when applying a screen protector to the Nintendo Switch. Hope this will save others the headache of misaligned screen protectors. Enjoy!
This was printed on a Prusa i3 MK3S using PLA at 0.2mm Layer Height and 10-15% infill to support bridging. No supports needed, runtime was a little over 30 mins.
Version 2 (V2) includes additional end tabs for better seating on the switch during application.
Just a quick design to help when applying a screen protector to the Nintendo Switch. Hope this will save others the headache of misaligned screen protectors. Enjoy!
This was printed on a Prusa i3 MK3S using PLA at 0.2mm Layer Height and 10-15% infill to support bridging. No supports needed, runtime was a little over 30 mins.
Version 2 (V2) includes additional end tabs for better seating on the switch during application.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
