Thingiverse
Nitecore headlamp handlebar mount
by mrak_iw
0
Downloads
1
Likes
0
Makes
It was designed for a Nitecore HC65 UHE headlamp, but it can fit other headlamps with the similar body diameter (23.6mm in this case).
This mount utilizes rubber o-rings of 4.5mm diameter.
It is the right part. To get the left one, just mirror it.
I've made two variants for different handlebar diameters: 31.8mm and 35mm.
There is a groove for a rubber pads to provide normal friction between the mount and a handlebar. I've used a piece of old bicycle tube with two-sided glue tape. Tested on stairs, rocks, roots, bunny-hops. Stays in place.
As a bonus: battery spacer for HCC65 UHE to use it with standard 18650 batteries. It utilizes a magnet d:8mm h:5mm.
FreeCAD model is parametric.
This mount utilizes rubber o-rings of 4.5mm diameter.
It is the right part. To get the left one, just mirror it.
I've made two variants for different handlebar diameters: 31.8mm and 35mm.
There is a groove for a rubber pads to provide normal friction between the mount and a handlebar. I've used a piece of old bicycle tube with two-sided glue tape. Tested on stairs, rocks, roots, bunny-hops. Stays in place.
As a bonus: battery spacer for HCC65 UHE to use it with standard 18650 batteries. It utilizes a magnet d:8mm h:5mm.
FreeCAD model is parametric.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!