Nitecore P20iX Nightstand Light

These are three parts that can turn your Nitecore P20iX into a nightstand light.

**Tail Stand **

I printed the tail stand in black PLA. I used a wall thickness of 1.2mm which makes it sturdy and stable enough. Infill density is irrelevant here as with the fins everything is pretty much two walls thick.

I added some feet to raise the base and some vent holes at the bottom. Should your battery vent, it will do so through the tail switch cap. I don't think it would propel the torch way too high, but I didn't want to take any chances.

The tail-fit into the base is purposefully slightly loose so you can switch the lamp on and off by pressing on the top of the diffuser till the tail switch clicks.

**Diffuser**

For the diffuser I used natural, glow in the dark, PLA. Wall thickness is 1.2mm as above and the infill is 20% Tri-Hexagon. This seems to give a good scattering of the light without absorbing it too much. You might want to experiment with other infill patterns or de