Thingiverse
No Soliciting Sign
von Robdeloach
170
Downloads
142
Likes
2
Makes
A "No Soliciting" sign to put on your front door. It is 240mm x 80mm x 2mm.
The base is 1mm with the letters and border raised another 1mm.
It is designed in Fusion 360 and printed on a Prusa MK2s.
I used the Prusa ColorPrint website to inject the code to change filaments at 1.2mm.
http://www.prusaprinters.org/color-print/
With the successful print, I did the filament change at 1.2mm. When I designed it, I planned to do the change at 1mm. But there was a problem when I did the color change at 1mm. As you can see by the close up photo, there is a flaw in the "N". It did the color change before the 1mm layer was 100% complete. It is hard to see if the difference if you do the color change at 1.2 and you can avoid the same problem I had with my first attempt at printing it.
The base is 1mm with the letters and border raised another 1mm.
It is designed in Fusion 360 and printed on a Prusa MK2s.
I used the Prusa ColorPrint website to inject the code to change filaments at 1.2mm.
http://www.prusaprinters.org/color-print/
With the successful print, I did the filament change at 1.2mm. When I designed it, I planned to do the change at 1mm. But there was a problem when I did the color change at 1mm. As you can see by the close up photo, there is a flaw in the "N". It did the color change before the 1mm layer was 100% complete. It is hard to see if the difference if you do the color change at 1.2 and you can avoid the same problem I had with my first attempt at printing it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
