Node 202 more 2.5" drives Mod

Warnings:
-The following guide doesn't guarantee success, if something goes wrong you are on your own.
-Some cable management / ziptie mounts might need to be flattened
-I haven't tuned the design yet

This mod requires:
-Sfx (non sfx-L and possibly non modular)power supply
-m3/m4 Drill bit
-Drill
-Two m3/m4 1cm long screws (not 11mm)
-Two m3/m4 nuts.
Possibly useful:
-Files to clean up the printed parts

Adds support for up to 6 x (2.5" 7mm thick drives), it works with the thicker ones too (15mm), plus as a bonus a 40x40x10 mm fan space (requires additional modding) to keep them cool.

Guide:
1)remove the hard drive caddy
2)Mark the 70mm gap between the psu and the internal support bracket with a pencil on the outer frame two straight vertical lines. You can first apply a layer of painter's tape to make it more visible
3)Place the base between the two lines and mark for each hole the center
4)Drill a 3mm wide(1.5mm diameter) hole
5)Almost done, put the base from t