Thingiverse
NodeMCU box
von 3DprintedScience
11
Downloads
9
Likes
1
Makes
This box was designed to contain a NodeMCU board and a breakout sensor boar. In my case I'm using a DS18b20 sensor to measure room temperature. There is a small space dedicated to the sensor to minimize the thermal effect due to the board heating.
Printed in 0.15mm layer height, 10% infill, with support for better results.
Printed in 0.15mm layer height, 10% infill, with support for better results.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
