NodeMCU Multi-Sensor Case

A revised version of the [Bruh Automation](https://www.thingiverse.com/bruhautomation/about) and [TrueOverFlow](https://www.thingiverse.com/thing:2477685) multi-sensor case that includes:
* Space for BH1750 light sensor
* Higher stand-offs for NodeMCU Amica board
* Pinch-clip at bottom of case to hold it together more effectively

Parts list to construct your own sensor:
* BH1750 light sensor
* AM312 PIR sensor
* NodeMCU v1 (Amica, NOT Lolin board)
* Red LED (used to show PIR triggered)
* 470 ohm resistor
* DHT22 Temperature/ Humidity Sensor
* Header wires (I'd suggest 10cm wires to get a nice "fit" inside the case!)
* USB Power Supply
* [Large Fresnel lens](https://www.aliexpress.com/item/7709-8-Fresnel-lens-body-infrared-sensor-switch-PIR-lens-diameter-26mm-lens-New/32591602278.html)

Use [Tasmota](https://github.com/arendst/Sonoff-Tasmota) as the firmware/ software. This works reliably with the attached GPIO configuration.