Thingiverse
NodeMcu V3 case
by saseru
32
Downloads
26
Likes
0
Makes
Case for node MCU v3.
Other models I found required the NodeMCU's PCB to have **rounded corners**. But mine has sharp corners, thus it did not fit there. So I created own model.
Held together with 2.6 mm screws; NodeMCU's PCB is clamped in between.
PartA is bottom shell, 9mm model to be used when pin headers are soldered. 4mm model only for use without pin headers.
PartB is top shell. Clearance with PartA is 0.15 mm.
Rev3 has thingiverse id and small improvement of screw holes in top part.
Other models I found required the NodeMCU's PCB to have **rounded corners**. But mine has sharp corners, thus it did not fit there. So I created own model.
Held together with 2.6 mm screws; NodeMCU's PCB is clamped in between.
PartA is bottom shell, 9mm model to be used when pin headers are soldered. 4mm model only for use without pin headers.
PartB is top shell. Clearance with PartA is 0.15 mm.
Rev3 has thingiverse id and small improvement of screw holes in top part.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
