Nomad Backplate RX Mode

This is a backplate if anyone is as _**stupid**_ as me and wants to use the Nomad as an RX.
**You will Void your warranty, since you will have to solder wires**

How to:
**This is experimental and I am not responsible for any damage caused by these settings.**
1. First, flash the device as **RadioMaster XR4.**
2. After that, connect to it via Wi-Fi and scroll down on the left side to Hardware Layout.
3. **Change RX and TX to 3 and 1,** as shown in the picture.
4. Then scroll down and set the RF Power. **I haven’t tested whether the radio can handle 2000 mW.**
5. Finally, scroll to the bottom and click Save Target Configuration.

If you have any problems, feel free to contact me.