Thingiverse
non-floor Door Stop
por Elvis2G5BS
7
Descargas
4
Likes
0
Makes
Doors sometimes are designed to automatically shut. Using that idea and wanting to keep the door open, a design to place a door stop between the door and door jam being held in place by the pressure of the door wanting to shut.
this is a simple project built in Tinkercad using English Units to remove objects from the walking path and keep material off the floor (no scuffing of tile or lack of grip issues). The designed hole allows for attachment on a belt, clip, a fig-it spinner or the ability to hang it up by the door when entering or leaving.
While wall thickness varies based on pressure, the machine used was in 0.4 mm with, so a 0.8 wall was designed (2 pass) to maintain the internal structure.
The internal has been solid, grid and pyramid designed, but the amount of space and the pyramid design did not meet the requirements (crushed).
If you buy the material and make it, based on the size at 3/4 inch tall, it could range from less than 50 cents US to $1.50 and customize
this is a simple project built in Tinkercad using English Units to remove objects from the walking path and keep material off the floor (no scuffing of tile or lack of grip issues). The designed hole allows for attachment on a belt, clip, a fig-it spinner or the ability to hang it up by the door when entering or leaving.
While wall thickness varies based on pressure, the machine used was in 0.4 mm with, so a 0.8 wall was designed (2 pass) to maintain the internal structure.
The internal has been solid, grid and pyramid designed, but the amount of space and the pyramid design did not meet the requirements (crushed).
If you buy the material and make it, based on the size at 3/4 inch tall, it could range from less than 50 cents US to $1.50 and customize
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
