Thingiverse
NorCal40A Enclosure
door JohnSutter
6
Downloads
7
Likes
0
Makes
This is an enclosure for Chuck Adam's spin of the classic NorCal40A CW Transceiver.
It's set up for parts I had on hand. I don't have part numbers for the parts used.
Probably never will.
This is a work in progress.
I'm not happy with the screws in the top, though the top stays in place without them.
I think I'd change the text to be cut into the body as opposed to setting on top.
On the one I printed, the text was hovering a mm or so above the body. That didn't
come out so well.
I used threaded inserts to hold the PCB, feet, and top. Either #4-40 or 3mm should work.
The speaker is just heat staked onto the top using the soldering iron and extra filament.
It's set up for parts I had on hand. I don't have part numbers for the parts used.
Probably never will.
This is a work in progress.
I'm not happy with the screws in the top, though the top stays in place without them.
I think I'd change the text to be cut into the body as opposed to setting on top.
On the one I printed, the text was hovering a mm or so above the body. That didn't
come out so well.
I used threaded inserts to hold the PCB, feet, and top. Either #4-40 or 3mm should work.
The speaker is just heat staked onto the top using the soldering iron and extra filament.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
