Noritsu LS600 rollers

Replacement rollers for my Noritsu LS600

I made them using caliper at first but I wasn't satisfied by the results.
I redesigned them after several tests using TPU 95A which is probably a bit too hard, I have to make new tests with TPU 60A but I still have to modify my Ender 3 for direct feeding and order some softer TPU.

With my new design I have no issue with my test films, I had some scratches and indents if I was respecting the original design of the old rollers. My new rollers do not have the same shape as the originals, they have a more basic shape but they work for me.

!!! WARNING !!!
I'm not responsible if you damage your scanner or your films.
Take your time, don't drink too much coffee and have a look to the service manual of your scanner, use the right tools and think about what you're doing before removing some nuts or screws because there are some springs and other small parts you may lose if you don't take enough care.
Have a look to the picture... first remo