Normandy SR-2

A fully re-cut version of the model produced by Wundel (https://www.thingiverse.com/thing:69086), inspired by 00meat.

Includes a couple of different variations on parts:
- No Fins: Removes the fins from the front and back of the main hull for printing as separate parts (original parts with fins included are also included)
- Small: Designed to be printed at smaller than 1/500 scale
- Holes: 5mm holes have been included for use at the following scales: 1/350, 1/500, 1/650 (original parts without holes are also included)

Note: Due to limitations of 3D printing, the vanes between the Front Inner and Outer Wing Flaps is not included - sheet styrene should be used to reproduce these.

Scaling Information:
- Base model is about 13" long when assembled
- 1/650 scale: 10", scale to 79%
- 1/500 scale: 13", scale to 94.5% (Recommended)
- 1/350 scale: 19", scale to 160%

"Go out there and give them hell. You were born to do this." - Garrus Vakarian