Not so Simple Spool Holder :-)

Thanks to bxd2000 I found a realy good looking spool holder. I took his wheels with +0,4mm holes and biger lower parts. Since I have spools in different wides and looking for more compact version, I make some changes on lower part with (separate, glued in) rails and a brand new "foot" with opposite rails. The holes for bolts are bigger - for M4x25 bolts. When you put rails together you need some silicone "like"grease, I used R.S.P. Slick Kick. on the foot I used some big foam pads from my stock, but you can use smaller ones and also make those holes for pads smaller...

It was quite a few days project to get all settings and measures about the rails right.

31.12.20 Aded a tray for filament clips that comes handy to me. You can print two of them if you like, you have a place to put instal them on both sides. I only need one for now. Be careful of the tray height. I have those foam pads on the bottom and the foot is three milimeters high in the air. Look at the picture and you'll g