Nova AC Delete Gauge Cluster

So I had two problems. One is the placement of my Temp, Oil, and Volt gauges and the other is the hole left by my mid-dash AC vent that was no longer being used and the vent parts were in sad shape.

Solution? Incorporate my 3D Printing hobby. Design and print a gauge cluster that fits the AC vent hole.

There are four parts,

1 - Top Lip which utilizes two screw holes to fasten. This gives the gauge cluster a place to slide up into.

2 - Gauge Cluster, there are three holes one for each gauge. I tried to make them a bit big and loose. A little electrical tape around the gauge will help the gauge fit snug without falling out.

3 - Two clips, these are made w/o holes for the screws so you can put them in the best place based on your situation. They clip on the lower dash edge.

I didn't full proof the design, I figure if you work on your car you have the smarts to improvise. Good luck and have fun!