Nozzle inspection base for Carson Microscope

Had an older Carson pocket microscope before getting into 3d printing. Thought I'd use it to look at some cheap nozzles bought off a popular website. Found it hard to keep them in focus by hand, so I whipped this up on tinkercad.

Comes in two parts - the interface and the base. The interface fits snug enough to hold itself on, but not so much as to be hard to remove. The base includes gaps to make it slightly loose, which was useful for slight movements while looking through the microscope. Scaling the base up slightly will make it fit tighter if desired.

Included a base for common v6 nozzles: most dropped in (hence the hex imprint) but a few I had to hand-turn. Your mileage may vary.

Also included blank base for holding other objects/modification.

TinkerCAD: https://www.tinkercad.com/things/cvGsQaDG001-microscope-interface-for-nozzle-inspection