Thingiverse
Nozzle, low pressure
von Peterpan101
40
Downloads
30
Likes
0
Makes
Various nozzles for low pressure watering (estimated at 0.5 - 1.0 bar).
Hose connection is barbed and designed for 10 mm hose (inner diameter).
The objective was to create a nozzle that is able to water my plants from 0.6 m above.
* Wide coverage (0.36 m2).
* Soft water droplets.
* High waterflow.
* Funtion properly with a low pressure (12vdc pump).
Through testing i have learned and used the following:
The nozzle is build out of 3 integrated nozzles with 3 features.
These integrated nozzles come together at a specific distance and angle and tip diameter,
This creates a colision and breaks the waterstream in droplets.
* Distance: sloped pressure build up and a directed stream.
* Angle: sets the spray area, smaller angle is a wider spray area.
* Diameter: sets the exit pressure, this controls the droplet size most.
Creating a water mist is possible with these nozzles by using a higher pressure pump.
Hose connection is barbed and designed for 10 mm hose (inner diameter).
The objective was to create a nozzle that is able to water my plants from 0.6 m above.
* Wide coverage (0.36 m2).
* Soft water droplets.
* High waterflow.
* Funtion properly with a low pressure (12vdc pump).
Through testing i have learned and used the following:
The nozzle is build out of 3 integrated nozzles with 3 features.
These integrated nozzles come together at a specific distance and angle and tip diameter,
This creates a colision and breaks the waterstream in droplets.
* Distance: sloped pressure build up and a directed stream.
* Angle: sets the spray area, smaller angle is a wider spray area.
* Diameter: sets the exit pressure, this controls the droplet size most.
Creating a water mist is possible with these nozzles by using a higher pressure pump.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
