Nozzle Unclogger (Simple)

This simple unclogger uses the piece of metal that splits the rings on the maker supply split ring keychains. This is for use when filament is stuck in the hot end, but is unable to be pulled out because it's below the hole where the filament enters the hot end. To use, turn on maintenance mode on your printer and heat up the hotend to where it will melt whatever filament is stuck. Then, take the nozzle out (be careful not to burn your hands on the hotend) and push out the filament using your unclogger. You may need to use glue or sticky tack to hold the metal piece in the print depending on the tolerances of your printer.Boost MeA boost would be SO helpful so I can keep up this hobby and design more models :)