Slicer Discord
NR600 Reset Switch to Type C Port Conversion – 3D-Druckmodell von Thingiverse Thingiverse

NR600 Reset Switch to Type C Port Conversion

von teeedubb
0 Downloads
0 Likes
0 Makes
Zum Modell
A bracket to mod a Type C port into the Cooler Master NR600 case. This will replace the reset switch, which I don't use - and you can hold the power button if you need to reset.

I used this type c cable - https://www.aliexpress.com/item/1005005397681858.html?spm=a2g0o.order_list.order_list_main.12.37f61802OZI8CV
30cm worked for me (MSI x670-p), but didn't leave much slack, so depending on where the port is on your motherboard, you may need a longer cable (50cm lengths are available on aliexpress).

This mod requires cutting down the cable, therefore the bracket will need to be modded to suit, so I have included the f3d file.

To remove the switch bracket there are 4 screws - one on the front of the case, one into the top of the case and two into the side of the case.
Once remove, remove the reset switch and you will need to cut down the switch clips so the inside of the cavity is completely flat. I've attached a photo but it is hard to see.
On the type c cable, cut down the w
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen