Thingiverse
NSX Rear Garnish Plug
por NSaneXr
4
Descargas
2
Likes
0
Makes
This is plug for the NSX rear garnish to help prevent water from entering the engine compartment and soaking the rear bank coils.
Version 1 is designed to use some kind of weather seal around the outside to make a watertight seal. Using a foam weatherstrip makes it easier to install.
Version 2 uses an o-ring for the seal. This slightly more difficult to use to get a good seal. Scaling will be required.
Depending on the material used to print, some scaling maybe required in order to get the right fit.
Version 1 is designed to use some kind of weather seal around the outside to make a watertight seal. Using a foam weatherstrip makes it easier to install.
Version 2 uses an o-ring for the seal. This slightly more difficult to use to get a good seal. Scaling will be required.
Depending on the material used to print, some scaling maybe required in order to get the right fit.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!