NUC5PPYB Case

Remix of the case by @Extrudable.

There were some issues with the renderings so I used the dimensions and hole locations to create a new shell.

I modified the hard drive mounts to make the hard drive snap in without screws and attached the bottom to the walls. This allowed me to add pegs to the bottom to hang off the back of my VESA monitor mount with less risk of it coming apart and crashing to the ground. A bit of glue on the plugs would be advisable.

I also made the button print-in-place so that it's less of a pain to assemble the box. Do not use supports on the lid.

The board is a TIGHT fit. I started with the HDMI port side tilted down first. I've only printed in ABS. More brittle prints will probably snap while forcing the board in.