Nuki Lock angled knob

This is an angled knob cover for the Nuki Lock.

My problem was, that the original knob collided with my doorframe. To install my Nuki lock, i had to design a 45 degree baseplate and a new knob.

To change the knob cover, you have to remove two little screws. Then, you can pull off the original cover.

After you finished your print, you have to break the button free. To do this, gently push the ring from inside.

I also published the Fusion360-file for remixing or improvements. If the knob doesn't fit perfectly, try adjusting the marked faces (see screenshot).
Also, there is a second model, which inner ring is a little bit lower. This leads to a flatter button.