Thingiverse
Numpad Case, Handwired Pro Micro
por bowiesjustaknife
5
Descargas
8
Likes
0
Makes
This is a case for a handwired numpad, controlled by an Arduino Pro Micro running QMK.
In order to hold the Arduino in place, I thought it would be easier to solder it to a perf board first. The perf board and switch plate slide in after everything is wired up and the front plate holds in place. Use the model to measure PCB dimensions and location of the Arduino to line up with the front USB hole.
The angle is 16 degrees, which is just enough for everything to fit with fairly tight clearances. It's still a little steep for my liking, but I don't care enough to redo it.
In order to hold the Arduino in place, I thought it would be easier to solder it to a perf board first. The perf board and switch plate slide in after everything is wired up and the front plate holds in place. Use the model to measure PCB dimensions and location of the Arduino to line up with the front USB hole.
The angle is 16 degrees, which is just enough for everything to fit with fairly tight clearances. It's still a little steep for my liking, but I don't care enough to redo it.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
