Thingiverse
Nut Spinner 3
von Cycon
7
Downloads
12
Likes
0
Makes
Just messing around and it turned out well, have not printed this one yet but i will soon!
NOTE: Nut size is 1/2 in. so 19mm(flat edge to flat edge)x22mm(point to point),12mmc(Inner Diameter)
NOTE: Bearing size: 22mm(OD)x8mm(ID)x7(Width)
NOTE: If the nut or bearing holes are too small, you can either file it down or use a flame to slowly push it out(nicer finish). For directions to use the flame look at my Nut Spinner 1
NOTE: Nut size is 1/2 in. so 19mm(flat edge to flat edge)x22mm(point to point),12mmc(Inner Diameter)
NOTE: Bearing size: 22mm(OD)x8mm(ID)x7(Width)
NOTE: If the nut or bearing holes are too small, you can either file it down or use a flame to slowly push it out(nicer finish). For directions to use the flame look at my Nut Spinner 1
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
