Thingiverse
Nut-trap_nutlock - MPCNC Primo
door doppiozero
3
Downloads
1
Likes
0
Makes
Prevents nuts from falling out of the "nut-trap".
After a couple of tool change nuts became loose and fall off, I had to remove the nut trap to get them in again. Quite annoying, so with this mod nuts should stay in place.
No need of modified nut-trap, just drill Ø2.5mm holes in it and use M3x5 screw ISO7380
After a couple of tool change nuts became loose and fall off, I had to remove the nut trap to get them in again. Quite annoying, so with this mod nuts should stay in place.
No need of modified nut-trap, just drill Ø2.5mm holes in it and use M3x5 screw ISO7380
doppiozero publiceert ook op
34 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
