Thingiverse
nutcracker base stand
von Kimlg
0
Downloads
2
Likes
0
Makes
Just a base stand for nutcracker.
I printed it at 0.4mm layer height and 1mm skin (top and bottom and sides), and 25% infill.
Enjoy using it and don't go nuts!
I printed it at 0.4mm layer height and 1mm skin (top and bottom and sides), and 25% infill.
Enjoy using it and don't go nuts!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!