Thingiverse
NuTone Replacement Range Vent Cover
von Paperskeletons3D
1
Downloads
0
Likes
0
Makes
My NuTone Range has a vent cover that was not there so I pulled up the manual and replicated the best I could from the drawings.
I used glue to hold it in place. This part creates a good seal so the air can go up the vent.
I used glue to hold it in place. This part creates a good seal so the air can go up the vent.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
