Thingiverse
nVidia Shield™ K1 Sun Shield
door Wolfie
55
Downloads
43
Likes
1
Makes
This is a snap on sun shield holder for the nVidia Shield K1. I don't have an original Shield to test so I don't know if this fits or aligns with it.
When using this, the headphone jack IS covered and can't be used.
This is designed for using the Shield K1 as a display for the DJI Phantom or Inspire series of drones. The center supports are lined up and are the correct width to set into the tablet holder on the RC unit (as seen in the photos). I designed this so the holder can remain on the shield and the sun shade can be removed, folded and slipped along with the tablet into a storage pocket in a case or backpack.
I used standard black poster board and velcro dots from the dollar store (2/$1 poster board and $1 for the dots). Total cost is around $2-$3 including filament.
While I flagged this as a remix, I only used a small section of the edge profile of the original item but I am giving credit for where I sourced the profile.
Sorry for the bad photos, battery was d
When using this, the headphone jack IS covered and can't be used.
This is designed for using the Shield K1 as a display for the DJI Phantom or Inspire series of drones. The center supports are lined up and are the correct width to set into the tablet holder on the RC unit (as seen in the photos). I designed this so the holder can remain on the shield and the sun shade can be removed, folded and slipped along with the tablet into a storage pocket in a case or backpack.
I used standard black poster board and velcro dots from the dollar store (2/$1 poster board and $1 for the dots). Total cost is around $2-$3 including filament.
While I flagged this as a remix, I only used a small section of the edge profile of the original item but I am giving credit for where I sourced the profile.
Sorry for the bad photos, battery was d
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!