Thingiverse
NXP QN9090DK Coaster
di max-o
0
Download
0
Likes
0
Makes
Designed to fit the NXP QN9090 development kit board, with a main board labeled "OM15076-3/JN5189 Carrier Main Board DK6 V3". Provides protection for the board when it's sitting on top of a pile of other hardware on your desk. Any expansion cards that go into the board should be able to freely sit on top of the case without interference.
Two notes:
1) Fit is tight, but if you wiggle the board back and forth, it should slip into place.
1) The board is fully supported, meaning that this case is probably over-engineered. It takes 67 g of filament with 20% infill. If you remix to remove some of the base of the case, you should be able to reduce the filament consumption and print time.
Two notes:
1) Fit is tight, but if you wiggle the board back and forth, it should slip into place.
1) The board is fully supported, meaning that this case is probably over-engineered. It takes 67 g of filament with 20% infill. If you remix to remove some of the base of the case, you should be able to reduce the filament consumption and print time.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!