NZXT H5 Flow (2024+) GPU Support

Stealthy GPU bracket to reduce sagging. Does not require case modification to install. The three M3.5 screws attach to the rear of the cable management shroud (see pictures). GPU bracket slides along rails to accommodate smaller or larger cards. Final case mount should fit properly (the one pictured in the photo was modified because I forgot to measure one dimension. The card used in the picture is RX 9060XT. The two holes on the top right are for additional attachments if needed, such as cable management clips, RGB hubs, etc. (Holes also fit M3 heat-set inserts)

Remixes welcome.

Parts Needed:
-4 M3x12mm screws to attach the case mount to the GPU support
-4 M3 heat-set inserts to thread into
-3 M3.5x10mm motherboard screws to mount the case mount to the case