O.MG cable programmer A+C case

This is a case for the O.MG cable programmer A+C from _MG_ (the product is available on Hak5 shop).


I asked about it to _MG_ and here is his answer:



I haven’t thought about a case for this. The bottom is the most prone to shorts, but I have the casing tabs extend farther than anything with voltage, so flat surfaces are safe. Everything else is pretty resistant to damage.
When I do DIY cases, I usually go for ultra low profile



I'm too rough with my pcb (or too bad lucked), then I made this case design. This is a WIP. I'm studying the best compact design for my needs. This model have a snap fit lid. For now, I share my first prototype. One have descriptive marks and the O.MG logo. The other is plain. The plain one can be more stealth.

Dimensions ≈ 32mm x 28mm x 12mm



PS: Actually, the leds hole is a little bit offset and the lid have a little gap.