O11 Dynamic XL Sensor Panel Bezel

This is a bezel for cleaning up the look of adding a sensor 7" display panel from Amazon. The Youtube video that inspired this can be found at https://youtu.be/T6C50GYZfEI

Use qty 4, 3mm x 6mm long cap head screws to mount the bezel to the screen.

It will fit perfectly into a O11 Dynamic XL on the rear panel where a 120mm fan goes. The screen is secured to the case via the provided silver 2.5 mm screws that come with it. These are normally used to mount a raspberry pi to it.

Prints in 3 hours.