Oboe Reed Case

This is a small case that's meant to hold an oboe reed. Note that it prints in one piece and the top section that prints on the bed of the printer will come out a little rougher, as the support will be directly adhered to the underside of that door. The hinges require a bit of careful support removal, as the support will be generated inside the loops. I've found that by pushing gently with a small tool like a miniature screw driver or small pick, the pieces come loose. It's sized to fit a layer of foam on the bottom, that should come with most oboe reeds at your local music store. I understand that some printers may have different results printing this, but after 7 different iterations on my Ender 3, it finally worked, and as long as you print slowly. (Closer to 100 mm/second) To close the door, you'll have to lift the latch and allow it to slid into the slot in the bottom section of the case, this should be secure enough.