OBS Ford Shift Boot Trim Ring

This is a shift boot trim ring for an OBS Ford with a standard transmission. Mine came out of a truck with a 460 & a ZF5, but I'm sure it'll fit others. The holes line up on mine but on mine the floor is sort of distorted, you might be slightly off or it might fit perfect, I'm not sure. I included two files, one with room for the foam backer & carpet to go under, and one without the room if you're just going to be running a bare floor like I am. The one in the pictures is the one with the gap in it for carpet & foam.

I printed it with a little fuzzy skin & the initial test piece out of PLA. It broke at the layer line where it is so thin, but I modeled after my broken original & did not have proper extrusion setup for the filament. I think it'll be just fine because I was also using some screws that were a little bit larger because all of my originals were gone. I printed it face down with no supports and 3 walls and 15% infill. As far as the body goes, it's stronger than the origin